Edge paint or burnish? Choosing a finish for your leather
Choose a finish that suits the leather and the job. A practical comparison of burnishing, edge paint and Fiebing’s Edge Kote, with preparation, testing and common faults.
Structured, workshop-tested leathercraft guides covering tools, edge finishing, stitching techniques, and practical knowledge for serious makers in the UK.
Choose a finish that suits the leather and the job. A practical comparison of burnishing, edge paint and Fiebing’s Edge Kote, with preparation, testing and common faults.
Mark the stitch line, keep the iron upright and plan the spacing before punching. A practical method for straight runs, curves and corners.
Leather thickness should suit the complete construction and the result you want. Common starting ranges are around 0.8–1.5mm for slim wallet layers, 1–1.5mm for card holders, 2–3mm for many bag panels and 3–4.5mm for belts. These are examples, not fixed rules: temper, lining, reinforcement, skiving and the number of layers all affect the finished piece.
There is no single finishing sequence after dyeing. Let the dye dry fully, buff away loose surface colour, then test the intended oil, wax, polish or topcoat on an offcut from the same leather. The right finish depends on the leather, dye, expected contact, required sheen and how the item will be used.
Punching clean leather holes requires the right punch diameter, a proper punching block or pad, a light positioning tap and then a firm controlled strike. Mark hole positions accurately before punching. A dull punch compresses and tears rather than cutting cleanly, so keep punch tips sharp. An arbor press produces more consistent results than hand mallet work for heavy leather or repetitive punching.
Leathercraft needs different surfaces for different jobs. Use a self-healing craft cutting mat for knife work, a proper punching block with a sacrificial vinyl or plastic pad for punches and stitching irons, and a stable marble or granite slab for skiving. If glass is used for skiving, it should be safety glass at least 10mm thick with safe edges and secure support. Never punch against stone, glass, metal or a self-healing craft mat.
Match leather sewing thread to the prepared hole, leather and stitch appearance. Our round waxed polyester sizes are 0.45mm for a lighter stitch line, 0.55mm for fine small-goods work and 0.65mm for a bolder line on mid-weight work. Use blunt harness needles that carry the thread through with slight resistance, and test the combination on an offcut.
The best beginner leather projects are key fobs, card holders, simple straps, and notebook covers. These are not chosen because they look impressive — they are chosen because they teach the skills that matter: clean cutting, consistent stitching, and proper edge finishing. A key fob done cleanly teaches more than a bag done badly.
I use linen thread for repairs and deliberately traditional pieces, and polyester where historical material is unimportant or the item needs to be hard-wearing. Both are available waxed or unwaxed. I prefer waxed thread and may still pass it across a wax block on a longer stitch run to make it easier to pull. I have only used Fil au Chinois linen, so this guide does not make a general quality claim across linen brands.
Test the complete dye-and-finish process on an offcut from the same leather before touching the final piece. Deglazer is useful where oils, waxes or surface treatments interfere with the intended colour, but it is not an automatic first step on clean unfinished leather. Apply the chosen dye in controlled coats, allow it to dry properly, then test the oil, wax, polish or topcoat needed for the finish you want.